| Specifications |
| OUTPUT |
| Power |
60W RMS per channel, 8ohms, 1KHz, <0.05% THD. 100W RMS per channel, 4ohms 1KHz, 0.05%THD. |
| Frequency Response |
20Hz to 20KHz, 0.5dB. |
| Signal to Noise Ratio |
106dB, 20Hz to 20KHz, Unweighted |
| Minimum Load |
4 ohms |
| Damping Factor |
>150 at 8 ohms |
| Slew Rate |
>20V/us |
| Connectors |
5mm screw lock captive screw connector, 4 poles. |
| Protection |
Thermal, Clip, Output shorting.
|
| INPUT |
| Sensitivity. |
-3dBu for full output |
| Impedance |
>10K ohms balanced/unbalanced. |
| Voltage Gain |
30dB |
| Max. Input level |
+18dBu |
| Channel separation |
>78dB |
| CMMR |
>80dB |
| Control |
Each channel by trimmer pot |
| Connectors |
Balanced via RJ45 screened connector (In / Out for other units connection), Unbalanced via RCA connector. |
| POWER |
| Mains requirements |
100 VAC to 240VAC 50/60 Hz |
| Mains socket |
Standard IEC |
| Typical consumption |
40 Watts at 1/4 power, 8 ohms |
| Quiescent |
8 Watts |
| Standby |
<3W |
| CONTROL / REMOTE / INDICATIONS |
| Control/ Input port |
RJ-45 socket, connection by CAT-5 screened cable |
| Mute |
Pin 5 connected to ground (Pin 7) |
| Standby |
Pin 4 connected to ground (Pin 7) or automatically after about 5 minutes without signal. |
| 12VDC |
For external devices as Hubs, Mixers, Players, etc. Maximum consumption 100mA. |
| Signal |
Presence of signal input of at least -24dB |
| Limiter/Protect |
LED indicator of clip limiting / short protection |
| GENERAL |
| Structure |
Metal case with convection aluminum heat sink cooling |
| Mounting |
1U rack or 1/2 with 2 short / long "ears". On wall & under table with 4 short "ears" (Supplied), table top with rubber legs |
| Dimensions |
H 4.4cm x W 21.6cm x D 19.2cm. (1/2 rack wide , 1U) |
| Weight |
Net = 1.7Kg, Shipping = 2Kg |
| Operating conditions |
-10... to +50..C Temperature, 10%-90% Humidity. |
| MTBF |
300,000 HOURS |
